How it works: 4-pin PWM MB port has 4 pins (oh man, thanks Cap. We have to follow same process as before, BUT the big difference is that we need 4-pin molex cable. It would go snug and fit secure.ĭone! Just plug it back to controller and you are good to go! Very simple.ĭo you see that there is enough space in the socket? We need to insert each extracted wire into proper slot. See little holes? Press on them and pull wires. There is enough room to fit 2 wires in 1 head slot. The idea is very simple, we need to extract pins from one head and insert them into another head, so there will be two fans goes into 1 4-pin head. You can use basically anything thin enough to fit a little hole on top of the head. We need tool to extract pins from the head. (Don't forget that you are doing at your own risk, this is not official Thermaltake guide) However in some cases you can connect 4-th and you won't notice any difference.įirstly, (too obvious) power off your PC. MB in most cases provides 12V Usually it will run up to 3 fans at max speed without any drawback (loosing RPM). Why I decided to divide in two parts? The answer is very simple. Second part will be about connecting up to 6 fans using same tools as in first case plus 4-pin Molex cable and electric tape (or shrinking tube or soldering iron + tape). This guide will divide in two parts: One of them is how to connect 4 fans in 1 controller, using only your hands and pin extractor (or any thin tools like needle). I would like to share my own experience of connecting Riing RGB fans together in 1 controller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |